ENGESTRIP PRÉ-600  
  It is a selective tin-lead alloys stripper developed to eliminate manual operations during the Ni-Au tab plating. It removes the solder coating and accelerates the stripping of the intermetallic film from the copper surface in the next process step with the Enegestrip POS 600. It works between 20 and 30°C, in 3 to 5 minutes.

  
  ENGESTRIP PÓS-600  
  Along with our Engestrip PRE-600, in few seconds it removes the final film the intermetallic from the copper surface leaving a clean active surface for a perfect adhesion of the following Ni and Au plate. It works betwen 20 and 30°C, in 20 to 40 seconds.  
  TOP  


     
  ALFASTRIP  
  It is an stabilized nitric stripper used to quickly remove the plated solder from the printed circuits boards in one step. It does not contain fluorides nor hydrogen peroxide. Of preference it should be used by spray giving a very rapid stripping and a minimum base copper etch. It can also be used by immersion, but in this case it demands work agitation and a longer time (between 2 and 3 minutes). It works between 20 and 30 °C, removing solder at a rate of 5 to 10 microns per minute.  
     
  ALFASTRIP PLUS  
  ALFASTRIP PLUS is a new stabilized nitric acid based stripping solution, used to quickly remove in just on stage the tin coat and the tin-lead alloy from the printed circuit boards

The ALFASTRIP PLUS differs from the ALFASTRIP by having a higher removal speed and higher metal concentration on the solution, making it more efficient and economic.


  
  TOP  


     
  DESPLAC NI-50  
  It removes the nickel layer on copper and copper alloy by simply dipping the board in the Ni-50 solution. It features a high yield, speed and low cost. It is supplied in a concentrated form to be diluted with water. It woks between 25 and 60 °C. The working speeds are: at 25 °C it removes 0,5 microns per minute, at 40 °C removes at one (1) micron per minute and at 60 °C removes 2 microns per minute.  
  TOP  

     
  DESPLAC AU-100  
  For the fast removal of gold coating over nickel, with any attack to the base metal. It is a low cost and high yield product. One liter strips 20 g of gold at a speed of one (1) micron per minute at 25 °C. Higher temperatures increase yield and speed. It comes ready to use.  
  TOP